新闻动态

NEWS

Company News

Industry News

What to do if the roller of Luoyang roller is overheated?

Release time:

2023-01-31

Source:

What should I do if the roller of Luoyang road roller overheats?

1. Before starting the Luoyang roller, it is necessary to preheat to reduce the starting resistance of the engine, improve the atomization and evaporation of fuel during starting, and form a good flammable mixture for easy starting. The simple method is hot water preheating, that is, heating the cooling water and then injecting it into the cooling system. When injecting hot water into the cooling system, you should open the drainage switch of the road roller, turn off the drainage switch, and wait until the temperature of the water flowing out reaches 30 to 40 degrees Celsius, stay there for 10 to 15 minutes, and start the engine until the water temperature in the engine water tank is consistent with the temperature of the cylinder block.

2. For diesel engines without preheating devices, please remove the air filter, drive the 4-ton drum engine, use spray to heat the air inlet (be careful not to enter the cylinder where debris is sucked in), and inhale flames when the engine inhales. After rotating for 1-2 seconds, supply oil again to start it.

3. When starting the roller at low temperature, the viscosity of the engine oil is high, and the lubricating oil is insufficient in a short time and cannot spread to various lubrication points. Therefore, the engine must be idle for a period of time after starting, and then load is added after the water temperature is normal.

How to choose a suitable Luoyang road roller?

In order to ensure the quality of the project, when choosing small and medium-sized rollers for construction, the appropriate Luoyang roller should be selected according to the specific construction environment. So how should you choose?

1. Select according to the specific requirements of the project. Some projects do not require high compression of the ground, while others require the ground to be very tight. Some roads need to be very smooth, while others simply press the road surface. The choice of small and medium-sized rollers for each project is naturally different, so you need to understand the requirements of the project before choosing a roller.

2. According to the selection of packaging materials. Some roads have compressed gravel, some have compressed asphalt, and some have only compressed soil. Because there are big differences between these compression objects, the needs for small and medium-sized rollers are also different, so you should also pay attention to this when choosing.

3. Choose according to the road level. Some roads are required to be at national level, some are Level II and some are lower. It is not necessary to have very good roller compression just to achieve the very low level of pavement in the country. This is a waste (Albert Einstein, Challenge). The small and medium-sized rollers in use cannot meet the requirements and cannot reach the national level, so this should be considered first when choosing.

Correctly identifying the quality of Luoyang road rollers is very important for many industries. It can extend the service life of the equipment to a certain extent and reduce a series of problems that occur in subsequent use. There are many manufacturers on the road roller market. To identify pressure and quality, you can check specific system parameters such as vibration parameters, engine, compression and climbing ability. It is very important to observe the hydraulic system and engine. Please do not choose an off-brand engine. There is no after-sales guarantee and the failure rate is relatively high. Choose a regular Luoyang roller.

More information